江蘇SLJ-2雨量計(記錄式)使用方法：

1、選擇空曠平坦的位置修筑一水泥平臺，按雨量傳感器三固定腳位孔在平臺上預埋三個固定螺絲（如安裝在屋頂或現有水泥平臺上，可直接打孔加膨脹螺絲固定），再將雨量傳感器牢固安裝。

2、將傳感器電纜引入室內，插入室內主機后側信號輸入插座內。

3、儀器使用內置電池前需對內部充電電池進行充電，充電時將隨機配備的電源適配器插頭插入儀器后面板上電源輸入插孔內。再將電源連接至～220V電源，此時“充電”指示燈點亮（充電時間大約在5～8小時）當“完成”指示燈點亮時表示電池已充足電，可進行正常使用。

4、使用時按下儀器后面板上的電源開關，液晶屏點亮，顯示“8234 雨量計”后即轉入正常測量狀態，同時狀態指示燈間隙閃亮，表示儀器處于史紀錄進行分段查詢顯示。

儀器正常使用時必須連續開機，共計雨量為當前日期前每日第24時的雨量統計值，如僅測量中間一段時間將不計入共計值內。